Our 12V 300ma 7 Watt or 500ma 10 Watt Regulated UL Listed Power Supplies (Transformers) are most commonly used for cameras (ours included). Works on 12V DC cameras that draw less than either of these MA ratings. However if your camera's specs draw within '50' of the 300ma limit, then we recommend choosing the next - the 500ma Power supply. Please call if you have any questions. Power supply cable is 6 ft. If you need more, please see Extension Cable (bottom).

Our Non-Regulated 12V 1AMP 20 Watt UL Listed Power Supply (Transformer) is used for a select few CCTV devices. Only one camera we carry uses this Power Supply (The T-Cam). However it is used on some of our Quad Processors, Dual Page Quads and HP Wireless Transmitters. Due to it's Non-Regulated current, when purchasing this product you must check the specs of that device to verify it's draw is well within this Transformers limits.  Please call if you have any questions or concerns.  Important: If you're planning on using this Power Supply with another CCTV device (not offered by us), we are not responsible nor liable for this products use. Power supply cable is 6 ft. If you need more, please see Extension Cable (bottom).

Would you rather use 24V power supplies for your 12V cameras? Is your cameras power source to located farther away than 300 ft. from the camera? If so, then why not purchase our 24 to 12 Power Converter? This nifty little device will allow you to have your power source distances of 1000 ft.+ away from the camera. Simply plug the Converter into the back of your 12V camera. Then attach your 18 gauge 2 conductor (two wires) to the other end of the Converter and run your wire. Once you've completed your run, attach the wires to our 24V Power Supply (listed below) or use another 24V Power source that offers similar output to achieve these distances. It's that simple!   

Our 24V 830ma or 1.7amp Regulated UL Listed Power Supplies (Transformers) are extremely common and are used for many cameras. While we currently do not sell cameras that require 24 volts, we recommend devices used with our power supplies not draw within '50ma' of the 830ma or 1.7amp limit. It's also a great companion to our 24 to 12 Power Converter (listed above).

Have you purchased something here in the USA, but need to use it overseas where the power source uses a different current? In the USA, power is rated at 110 AC, however in many locations overseas (Europe for example) uses 220 AC. If this is the problem you face, then simply purchase our 220 to 110 Power Converter. Plug your 110 AC (USA) device into the back of the Converter, then plug the Converter into the wall. That's all there is to it!

Rather not run coax cabling to send video signal(s)?   Do you already have an existing pair of phone wire (22 gauge, 2 conductor) running to the cameras location? If so, then this is your answer! Simply take your Cameras video cable (either BNC or RCA type end), attach it to one end of our Transmitter. Then attach your phone wire (two wires) to the other end of our Transmitter. From there, your phone wire will send video up to 1800 ft. away. Once you reach the location that you want to change back over to BNC or RCA ends, simply attach one more of these Transmitters to that end and you're all done. Folks, installation doesn't get any simpler than this...

Includes: Two - 2 Conductor Video Transmitters.

Can't find a power outlet nearby your cameras location? Then purchase our power supply Extension Cable. Offered in 30 or 100 ft. lengths which include Male and Female ends so that you can add other extensions as needed. Not recommended to exceed 200 ft. when using 12 Volt 300ma power supply or 300 ft. using a 500ma as the voltage begins to drop and can hurt your camera. If you require farther distances and are using a 12V camera, please see our 24 Volt AC/DC Transformer Power Supply that can be used in conjunction with our 24V to 12V Converter (above).

Converts your vehicles cigarette lighters power (DC) to regular AC power. Offers the user two regular AC outlets. Simply plug the power adapter into your automobile cigarette lighter, turn the unit On, and plug your AC devices into either or both outlets and you're set. Perfect for those who who wish to attach/use a camera and VCR, or possibly a small TV/Monitor and VCR or when using a wireless Receiver unit (for wireless cameras) and TV or VCR to record with in their vehicle. Other features included are: Low Battery Alarm and Shutdown i.e. Alarm if power drops below 10.2 volts, Shutdown if power drops below 9.6 volts which prevents unexpected dead car batteries, Automatic Overload Detection and Shutdown if continuous power draw exceeds 350 watts, Automatic Short Circuit Detection and Shutdown.